View source for Install MikroTik CHR on VPS

[[Category:Networking]]
Misc notes on installing a MiktoTik CHR on a VPS

=Install=
Spin up VPS with some Debian based Linux distro and login.  Then run the following to replace the install with a MikroTik CHR:

 apt-get install unzip
 wget https://download2.mikrotik.com/routeros/6.40.1/chr-6.40.1.img.zip -O chr.img.zip && \
 gunzip -c chr.img.zip > chr.img && \ 
 mount -o loop,offset=33554944 chr.img /mnt && \ 
 ADDRESS=`ip addr show ens3 | grep global | cut -d' ' -f 6 | head -n 1` && \ 
 GATEWAY=`ip route list | grep default | cut -d' ' -f 3` && \ 
 echo "/ip address add address=$ADDRESS interface=[/interface ethernet find where name=ether1] /ip route add gateway=$GATEWAY " > /mnt/rw/autorun.scr && \ 
 umount /mnt && \ 
 echo u > /proc/sysrq-trigger && \ dd if=chr.img bs=1024 of=/dev/vda && \
 reboot

*Once done you should have the system power off and then back on to reboot into the MikroTik CHR

=Config Networking on CHR=
Set $ADDRESS and $GATEWAY first or replace them in the line below (as it appears in the script above) with the actual values

 echo "/ip address add address=$ADDRESS interface=[/interface ethernet find where name=ether1] /ip route add gateway=$GATEWAY